Plasterers Covering Ireland Wood and Holt Park Edge
Ceilings made flat, walls given a fresh skim and tired plaster put right in the post-war houses around Iveson Drive and Otley Old Road on the north-west edge of Leeds.

Ireland Wood · LS16
Post-war homes around Iveson Drive
Ireland Wood is a post-war estate built on the north-west edge of the city, with semi-detached houses, short terraces and some low-rise flats laid out along roads such as Iveson Drive and towards Holt Park. Otley Old Road runs along one side. The houses are mostly brick with cavity walls, plastered internally in gypsum or sand and cement backing coats with a thin finish over the top.
Ceilings are generally plasterboard, and many of them were given a textured coating at some point in the 1970s or 1980s. Original fireplaces have often been removed and chimney breasts blocked or taken out, and most houses have been rewired and had heating replaced. All of that leaves its mark on the walls, which is where a lot of our work here begins.
Lifting dated rooms in Ireland Wood houses
Textured ceilings are a regular job. Because older textured coatings may contain asbestos, the ceiling is sample-tested before work starts. The usual method is to seal and skim over the top, or to overboard and skim where the ceiling is cracked or sagging. Sanding and scraping are not used. Either way the room ends up with a smooth ceiling and a much lighter feel.
On walls, the common issues are hollow backing coats around old fireplace openings, cracked patches over cable chases and uneven repairs from past work. Loose areas are cut out and replastered, chases are filled and bonded, and then the wall is skimmed. Where a chimney breast has been removed or a doorway blocked up, we board or plaster the area so it blends with the rest of the room.
Arranging plastering at your Ireland Wood home
Most houses here have reasonable access from the road, and many have a drive, which helps with unloading materials and taking waste away. We cover floors, stairs and furniture, and keep dust within the room being worked on. If you are having several rooms done, we can tackle them one after another so the house stays usable throughout.
It is worth having plastering done after electrical and plumbing work but before decorating and new flooring. Tell us what other trades are planned and we will fit in at the right point. The visit and quote are free, and the written quote lists each wall and ceiling so you can compare options or split the job into stages.
Services
Most asked-for in Ireland Wood

Skimming & reskimming
A thin, hard new face on walls and ceilings that are sound underneath but look tired, patched or lumpy.
See the service
Artex covering & removal
Swirls, stipples and peaks made flat again.
See the service
Patch & crack repairs
Holes left by the electrician, cracks over doorframes, knocked corners and the patch where the old boiler used to be.
See the serviceAlso in Ireland Wood
Everything else we do
FAQs
Plastering in Ireland Wood: questions
Can my Ireland Wood ceiling be made flat without removing the texture?
Yes, and that is the usual route. After a sample test, the textured surface is sealed and skimmed over, or new plasterboard is fixed across it and skimmed. Either way, the original coating stays sealed in place and is not sanded or scraped.
What do you do where a chimney breast has been removed?
We make good the wall and ceiling where the breast used to be, boarding or plastering to bring it flush with the surrounding surfaces, then skim so the change is not visible. Removal should be done properly with the right support first, which is a job for a builder.
Should I plaster before or after rewiring my Ireland Wood house?
After. Rewiring involves chasing walls and lifting floors, and plastering afterwards covers all of that in one go. In Ireland Wood houses, we usually follow the electrician, fill the chases and then skim the rooms ready for decoration.
Will skimming hide cracks permanently?
Skimming covers cosmetic cracks and, with any joints taped first, gives a sound surface. If a crack is caused by ongoing movement, it may return, so we look at the pattern and width before skimming and tell you if there is anything that needs looking into first.