Artex covering and removal in Leeds
Swirls, stipples and peaks made flat again. We test older textured coatings first, then skim or overboard so the ceiling ends up smooth and modern.

Artex covering & removal
What the job involves
Textured coatings were fitted in huge numbers of Leeds homes from the 1960s to the 1990s, on ceilings and sometimes on walls. They were often used to hide cracks, which means a smooth new ceiling sometimes needs a little repair work underneath as well.
Some textured coatings applied before 2000 contain a small amount of asbestos. It is safe while it is left alone, but sanding, scraping or drilling it can release fibres. So before we disturb any older textured finish, a sample is sent off for testing. Most of the time the simplest and safest answer is to leave it in place: the sharp peaks are carefully knocked down only where the result allows, the surface is sealed, and it is skimmed over in two coats.
Where a textured ceiling is too heavy or uneven to skim, we overboard it with new plasterboard and skim that instead, which encloses the old coating completely. If you want a textured ceiling physically removed and the test shows asbestos, that work is done by a specialist following HSE guidance before we plaster.
On the day
Step by step
- 1
Test
A small sample of older coatings is sent for analysis before anything is disturbed.
- 2
Plan
Skim over, overboard or specialist removal, depending on the result and the ceiling.
- 3
Prepare
Surface sealed and primed; any loose areas and cracks made good.
- 4
Finish
Two-coat skim or new boards and skim, ready to decorate.

Before you book
Good to know
Do not sand it
Never sand, scrape or steam off an old textured ceiling before it has been tested. Leaving it alone is the safe default.
Light fittings
Ceiling lights and smoke alarms are taken down before skimming and need refitting afterwards, ideally by an electrician.
Areas
Artex covering & removal across Leeds
We carry out this work throughout the city and in the towns and villages around it, including these areas.
All areasFAQs
Questions about artex covering and removal
Does all Artex contain asbestos?
No. Only some textured coatings applied before 2000 contain it, usually in small amounts. The only way to know is to test a sample, which we arrange before starting.
Can you plaster over Artex?
Yes. Sealing the surface and skimming over it is the most common way to get a smooth ceiling, and it avoids disturbing the coating.
Is overboarding better than skimming over Artex?
For heavy, deep or cracked textures, overboarding often gives a flatter result. For lighter textures, a sealed skim is usually enough. We will look and advise.
Can you remove Artex from walls?
Textured walls can be skimmed over or overboarded in the same way as ceilings. If removal is needed and asbestos is present, a specialist carries that part out first.
Walls or ceilings need sorting?
We come out, look at the plaster with you and send a written quote. Free, and no obligation.