Plastering Across Austhorpe
Reskimming, ceiling work and repairs for the semis around Austhorpe Lane and Manston Lane, aimed at turning tired, patched walls into smooth surfaces ready for paint.

Austhorpe · LS15
Semis between Cross Gates and the ring road
Austhorpe sits on the eastern edge of Leeds, with many of its homes built as semi-detached houses in the years either side of the Second World War. Roads off Austhorpe Lane and Manston Lane are typical of that period: brick walls plastered with the backing coats common at the time, then finished with a thin setting coat. Ceilings were usually plasterboard or, in some of the earlier houses, lath.
After seventy or eighty years most of these houses have seen rewiring, new central heating, replacement windows and a kitchen or two. Each change left channels, holes and filled areas behind. The plaster underneath is often still sound, but the surface has become a patchwork of different materials. That is why a reskim, rather than a full replaster, is so often the right call in this part of LS15.
Textured ceilings and the wear of later alterations
Plenty of Austhorpe semis still have swirled or stippled ceilings from the 1970s and 80s. Older textured coatings can contain asbestos, so we arrange for a sample to be tested before the surface is disturbed. In most cases the coating is then sealed and skimmed over, or the ceiling is overboarded with new plasterboard and finished. Neither method involves scraping or sanding, which keeps dust and risk down.
On the walls, age shows up differently. Hairline cracks around door frames, blown patches behind old radiators and bumpy areas where a fireplace was removed all come up regularly. We cut out anything loose, rebuild the depth with a suitable backing plaster, and then skim the full wall so the repair disappears. Where damp has caused the problem, the cause needs fixing first, because new plaster will not survive a wet wall.
Planning a reskim in a lived-in family home
Most of our Austhorpe work is in occupied homes, so we plan rooms in an order that keeps the house usable. A bedroom or lounge can usually be prepared, skimmed and left to dry without disrupting the rest of the house for long. Furniture is moved to the middle or into another room, floors are sheeted and sockets and switches are loosened so the plaster runs neatly behind them.
Semi-detached houses usually have a drive or street parking close by, which helps when we carry in boards and bags. We start with a free visit to look at the walls and ceilings, check for hollow spots and any textured coatings, and talk about the finish you want. A written quote follows, listing each room and what is included so there are no grey areas.
Services
Most asked-for in Austhorpe

Skimming & reskimming
A thin, hard new face on walls and ceilings that are sound underneath but look tired, patched or lumpy.
See the service
Artex covering & removal
Swirls, stipples and peaks made flat again.
See the service
Patch & crack repairs
Holes left by the electrician, cracks over doorframes, knocked corners and the patch where the old boiler used to be.
See the serviceAlso in Austhorpe
Everything else we do
Next door
Areas nearby
FAQs
Plastering in Austhorpe: questions
Is my Austhorpe semi likely to have asbestos in the ceiling texture?
Some textured coatings applied before 2000 contained a small amount of asbestos, so it cannot be ruled out by looking. We arrange a sample test before any work on an Austhorpe ceiling. The usual approach afterwards is sealing and skimming or overboarding, never sanding or scraping.
Can you skim over old plaster that has been painted many times?
Usually, yes. Painted walls are cleaned, any flaking paint is removed and a bonding coat or PVA is applied so the new plaster grips. If the old plaster underneath is hollow or crumbling, that area is cut back first. We check this at the visit by tapping across each wall.
How messy is a reskim in a typical Austhorpe house?
Skimming is wet work rather than dusty work, so the mess is mostly drips and splashes, which we control with sheeting and masking. Preparation such as cutting out loose patches does create some dust, and we keep that to the room being worked on. We clear up at the end of each day.
Do you replaster walls behind radiators?
Yes. For the neatest result the radiator is taken off the wall first, usually by a plumber you arrange, so the wall behind can be skimmed in one piece. Working round a fixed radiator leaves a visible edge and a strip of old surface that never quite matches.